calvast.blogg.se - Sophos utm home versus sophos xg firewall home

Sophos utm home versus sophos xg firewall home how to#
Sophos utm home versus sophos xg firewall home free#

When installing the UTM, you must select a LAN NIC. insert the “WAN NIC” via PCI Passthroughīe sure if it is the right PCIe slot and NIC.I recommend virtio for NIC device model, because according to my own experience it offers the best data throughput. activate the bridge mode for the “LAN NIC”.activate auto start while booting of the hypervisor.We have been busy and now have a fully installed Ubuntu and Virt Manager and are starting to configure the virtual UTM. With PCI Passthrough, all traffic goes directly to the virtual firewall and cannot escape from a virtual switch and has no logical contact with the hypervisor (the Ubuntu server). Why do I use PCI Passthrough? It is safer. you need a pcie slot for the NIC where the PCIe lanes are not shared with the chipset or other components.and the last NIC via PCI Passthrough exclusive for the UTM WAN interface (you can’t use a dual NIC for this).the second NIC in bridge mode for the VMs.

I use the Mainboard NIC for the Server management.

A Ubuntu System (with a GUI, it’s easier ) ).

The following link deals with the basic configuration of virt manager under ubuntu: In this article I assume that Ubuntu and virt manager are installed. Similarly, we can set rules for other services and ports.Today I will tell you how I configured my home server for a virtual Sophos UTM.Īll configurations in ubuntu can also be used for a virtual Sophos XG. We set up port 80 of our public IP address to forward to port 80 of our server on the local network. In the example above, the addressing of the server’s subnet is different than the IP address of the physical port, so don’t forget to set the appropriate routing.

Sophos XG Firewall setting an HTTP redirect rule.

in Forward section in Protected server(s), select the previously created IP host and Mapped port should be set to service port.

Destination host/network set to the physical port with the set IP address to which the ISP redirects our external IP address and in Services we select the service that we allow.

Source zones and Allowed client network on Any unless you want to allow only certain networks.

Rule group can be left on Automatic or select as below.

Application template from DNAT/Full NAT/Load Balancing.

Nextly, we create a firewall rule from the Firewall menu, select Add firewall rule and Business application rule, and then: To do this, go to Hosts and Services and then to the IP host tab and click the Add button.

Sophos utm home versus sophos xg firewall home how to#

I will only show you how to redirect your public IP address to the address of the server located in the LAN, as I have done in my case and thanks to that you can read my blog 🙂įirstly, we will create a host that will be used in the firewall rule that handles redirection. Maybe I will not describe how to configure Sophos XG Firewall, because many tutorials can be found on the Internet and it is also quite intuitive.

Sophos utm home versus sophos xg firewall home free#

After several years of working with these devices, I wanted to set something like this at home and found a free Sophos home solution.

After a short analysis, it turned out that it is a new generation of firewall with an extensive security system and many other network functions. The adventure with UTM devices began many years ago, when the name FortiGate appeared in the specification during one of the implementations.